俞宏英, 孙冬柏, 杨德钧. 模拟焊接条件对镍磷非晶态合金结构和性能的影响[J]. 工程科学学报, 1996, 18(S2): 73-76. DOI: 10.13374/j.issn1001-053x.1996.s2.016
引用本文: 俞宏英, 孙冬柏, 杨德钧. 模拟焊接条件对镍磷非晶态合金结构和性能的影响[J]. 工程科学学报, 1996, 18(S2): 73-76. DOI: 10.13374/j.issn1001-053x.1996.s2.016
shu
Yu Hongying, Sun Dongbo, Yang Dejun. Effect of Simulated Welding Condition on the Structure and Properties of Ni-P Amorphous Alloy[J]. Chinese Journal of Engineering, 1996, 18(S2): 73-76. DOI: 10.13374/j.issn1001-053x.1996.s2.016
Citation: Yu Hongying, Sun Dongbo, Yang Dejun. Effect of Simulated Welding Condition on the Structure and Properties of Ni-P Amorphous Alloy[J]. Chinese Journal of Engineering, 1996, 18(S2): 73-76. DOI: 10.13374/j.issn1001-053x.1996.s2.016
shu

模拟焊接条件对镍磷非晶态合金结构和性能的影响

Effect of Simulated Welding Condition on the Structure and Properties of Ni-P Amorphous Alloy

    摘要
  • 摘要: 通过不同的热处理条件模拟焊接过程的温度和时间,对化学镀N1-P非晶态合金的结构、性能进行了研究。结果表明:当热处理时间在60s以内时,Ni-P合金不会发生晶化(1000℃,60s除外),仍然保持非晶态,但是镀层硬度明显得到了提高,在较短时间的热处理条件下,镀层硬度在700℃处取得最大值。

     

    Abstract: The structure and properties of electroless Ni-P amorphous alloy under the simulated welding condition by changing the temperature and time of heat treatment were investigated.It has been shown that the crystallization of Ni-P alloy would not accur when time of heat treatment is shorter than 60 seconds.(beside 1000℃,60s),but the hardness of the alloy increases obviously.Under the condition of heat treament with shorter time,the handness of the alloy reaches the maximum when the temperature of heat treatment is 700℃.

     

    • HTML全文
    • 参考文献(0)
    • 相关文章
    • 施引文献
  • 资源附件(0)

/

返回文章
返回