厚壁圆筒砂岩力学特性及损伤破裂机理试验研究

Experimental study on the mechanical behavior and damage fracture mechanism of thick-walled hollow cylindrical sandstone

  • 摘要: 为研究开采过程对地下工程稳定性的影响,采用厚壁圆筒三轴压缩试验,研究了围压和内径对厚壁圆筒砂岩试样强度及变形特性的影响;通过实时声发射监测和X射线CT扫描技术探讨了厚壁圆筒砂岩的损伤破裂特征. 力学试验结果表明:厚壁圆筒砂岩试样的弹性模量和割线模量仅与围压呈强正相关性,与厚壁圆筒内径无显著关系;围压对厚壁圆筒砂岩试样的峰值强度具有强化作用,非线性霍克–布朗准可更好地表征两者间的关系. 声发射测试结果表明:围压提升导致试样峰值声发射振铃计数衰减;在低围压条件下,随着孔径增大,峰值声发射振铃计数呈降低趋势,而在高围压条件下,峰值声发射振铃计数与孔径无显著关联性. CT结果表明:随着围压和孔径增大导致厚壁圆筒试样的宏观破裂角度降低,孔道内壁的破裂程度加剧;相同围压条件下,孔径增大会显著提高三维裂纹体积占比和分形维数;相同孔径砂岩试样,单轴压缩下试样的三维裂纹体积占比和分形维数最高,而在三轴压缩条件下,试样内部裂纹体积占比随围压增加而降低,但其分形维数与围压呈显著正相关.

     

    Abstract: This study investigated the influence of the mining process on the stability of underground engineering. Firstly, the influence of the confining pressure and inner diameter on the strength and deformation characteristics of thick-walled hollow cylindrical sandstone specimens was studied using thick-walled hollow cylinder triaxial compression tests. Secondly, the damage and fracture characteristics of thick-walled hollow cylindrical sandstone were explored using real-time acoustic emission (AE) monitoring and computed tomography (CT) scanning. Mechanical test results showed that the elastic and tangent moduli of the thick-walled hollow cylinder sandstone specimens showed only a strong positive correlation with the confining pressure, and there was no significant relationship with the inner diameter of the thick-walled hollow cylinder sandstone. The confining pressure had a significant reinforcing effect on the peak strength of the thick-walled hollow cylinder sandstone, and the nonlinear Hawk-Brown criterion could better characterize the relationship between them. As the hole diameter increased, the peak deviatoric stress of the thick-walled cylindrical sandstone specimens exhibited a linearly decreasing trend, and the linear correlation coefficient between the two increased with increasing confining pressure. As the confining pressure and hole diameter increased, the volumetric expansion of the thick-walled cylindrical sandstone specimens decreased. This indicates that under higher confining pressures, the thick-walled cylindrical specimens with large hole diameters deformed toward the inner walls of the hollow. As the confining pressure increased, the Poisson’s ratio of the thick-walled cylindrical sandstone specimens decreased. Under uniaxial compression, the Poisson’s ratio of the specimens was independent of the hole size. However, under triaxial compression, the Poisson’s ratio of the specimens showed a downward trend as the hole size increased. The AE test results indicated that the peak AE ringing counts of the specimens decreased because of the increase in the confining pressure. At the lower confining pressure, with the increase in the hole diameter, the peak AE ringing counts tended to decrease, whereas at the higher confining pressure, the peak AE ringing counts had no significant correlation with the hole diameter. The CT results showed that with the increase of the confining pressure and hole diameter led to the decrease of the macroscopic fracture angle of the thick-walled hollow cylinder specimens and the increase of the fracture degree of the inner wall. Under the same confining pressure, the increase in the hole diameter significantly increased the three-dimensional cracking volume percentage and fractal dimension. For the same hole diameter sandstone specimen, the uniaxial compression of the specimen had the highest three-dimensional cracking volume percentage and fractal dimension, and under the triaxial compression condition, the cracking volume percentage of the specimen's internal cracks decreases with increasing confining pressure; however, its fractal dimension was significantly positively correlated with the confining pressure. This study emphasizes the importance of the burial depth and excavation size for the stability of underground engineering tunnels. The results further revealed the synergistic impact mechanism of the two factors on the surrounding rock failure of the tunnels. This indicates that as the burial depth increases, the deformation and damage cracking phenomena of large tunnels become more severe, leading to a significant increase in maintenance costs in the later stage. Measures such as deformation control should be adjusted based on the confining pressure and cross-sectional size.

     

/

返回文章
返回