李华德, 吴小鸣, 王继海, 赵殿甲, 王顺晃, 黄承云. 微型计算机控制起动式飞剪的控制模型和软件设计[J]. 工程科学学报, 1987, 9(2): 69-72. DOI: 10.13374/j.issn1001-053x.1987.02.010
引用本文: 李华德, 吴小鸣, 王继海, 赵殿甲, 王顺晃, 黄承云. 微型计算机控制起动式飞剪的控制模型和软件设计[J]. 工程科学学报, 1987, 9(2): 69-72. DOI: 10.13374/j.issn1001-053x.1987.02.010
shu
Li Huade, Wu Xiaoming, Wang Jihai, Zhao Dianjia, Wang Shunhuang, Huang Chengyun. Flying Shears Controlled by the Micro-Computer Control System[J]. Chinese Journal of Engineering, 1987, 9(2): 69-72. DOI: 10.13374/j.issn1001-053x.1987.02.010
Citation: Li Huade, Wu Xiaoming, Wang Jihai, Zhao Dianjia, Wang Shunhuang, Huang Chengyun. Flying Shears Controlled by the Micro-Computer Control System[J]. Chinese Journal of Engineering, 1987, 9(2): 69-72. DOI: 10.13374/j.issn1001-053x.1987.02.010
shu

微型计算机控制起动式飞剪的控制模型和软件设计

Flying Shears Controlled by the Micro-Computer Control System

    摘要
  • 摘要: 本文介绍了起动式飞剪的剪切控制模型,分析了影响剪切精度的原因,提出了一种用软件手段消除剪切误差的方法。工业试验证明:根据控制模型研制的软件是可行的,它使剪切误差下降到定尺的0.7%,成品率提高6%。

     

    Abstract: A start-tyPe flying shear controlled by the micro-computer control system can complete the works of cut head and tail, cut-to-length and cut-to-average length for high speed continuous hot rod mill.Based on the Principle, it can descride the shearing errors and the method of improving accuracy.The hardware figures and softwares block diagrams of the system are Presented in this Paper.
    It has been proved by the industrial scale experiment that the shearing eorror was decreased greatly.

     

    • HTML全文
    • 参考文献(0)
    • 相关文章
    • 施引文献
  • 资源附件(0)

/

返回文章
返回