牛四通, 成国光, 张鉴, 佟福生. 精炼渣系的发泡性能[J]. 工程科学学报, 1997, 19(2): 138-142. DOI: 10.13374/j.issn1001-053x.1997.02.004
引用本文: 牛四通, 成国光, 张鉴, 佟福生. 精炼渣系的发泡性能[J]. 工程科学学报, 1997, 19(2): 138-142. DOI: 10.13374/j.issn1001-053x.1997.02.004
Niu Sitong, Cheng Guoguang, Zhang Jian, Tong Fusheng. Foaminess of Refining Slags System[J]. Chinese Journal of Engineering, 1997, 19(2): 138-142. DOI: 10.13374/j.issn1001-053x.1997.02.004
Citation: Niu Sitong, Cheng Guoguang, Zhang Jian, Tong Fusheng. Foaminess of Refining Slags System[J]. Chinese Journal of Engineering, 1997, 19(2): 138-142. DOI: 10.13374/j.issn1001-053x.1997.02.004

精炼渣系的发泡性能

Foaminess of Refining Slags System

  • 摘要: 针对CaO-MgO-Al2O3、SiO2-CaF2五元精炼渣系进行了有关发泡性能的实验.实验结果表明:(1)随着吹气量的增加,炉渣相对发泡高度相应增加,两者之间存在着较好的线性关系;(2)当炉渣碱度<2.5时,炉渣中MgO质量分数在11%左右对炉渣发泡有利,而在高碱度操作时MgO质量分数则应该低一些;(3)对于低碱度渣,控制Al2O3为15%;(MgO)+(Al2O3)为20%~26%较好;(4)炉渣碱度对发泡性能的影响比较复杂,在特定的MgO,Al2O3,CaF2成分范围内,炉渣碱度B在1.9左右发泡性能最好.

     

    Abstract: The experiments on the foaminess of the CaO-MgO-Al2O3-SiO2-CaF2 refiniug slag system have been carried out.The obtained results are as follows: (1) relative foaming height linearly increases with the increasing of the flowrate of blowing gas; (2) the proper content of MgO is about 11% when slag basicity B<2.5 and it should lower when slag basicity will be higher, (3) the better content of Al2O3, (MgO)+(Al2O3) is 15% and 20%~26% respectively at the range of lower basicihes; (4) the effect of slag basicity on the foaminess is complex and its ophmizing value is 1.9 at the specific contents of MgO, Al2O3 and CaFe2.

     

/

返回文章
返回