晏洪波, 张丽英, 徐晓娟, 李汶霞, 吴成义. 超细钨粉碳化时碳黑粒径对WC粉化合碳的影响[J]. 工程科学学报, 2000, 22(6): 536-538. DOI: 10.13374/j.issn1001-053x.2000.06.013
引用本文: 晏洪波, 张丽英, 徐晓娟, 李汶霞, 吴成义. 超细钨粉碳化时碳黑粒径对WC粉化合碳的影响[J]. 工程科学学报, 2000, 22(6): 536-538. DOI: 10.13374/j.issn1001-053x.2000.06.013
YAN Hongbo, ZHANG Liying, XU Xiaojuan, LI Wenxia, WU Chengyi. Influences of Carbon Black Particle Size on the Compounded Carbon Content in WC Powders[J]. Chinese Journal of Engineering, 2000, 22(6): 536-538. DOI: 10.13374/j.issn1001-053x.2000.06.013
Citation: YAN Hongbo, ZHANG Liying, XU Xiaojuan, LI Wenxia, WU Chengyi. Influences of Carbon Black Particle Size on the Compounded Carbon Content in WC Powders[J]. Chinese Journal of Engineering, 2000, 22(6): 536-538. DOI: 10.13374/j.issn1001-053x.2000.06.013

超细钨粉碳化时碳黑粒径对WC粉化合碳的影响

Influences of Carbon Black Particle Size on the Compounded Carbon Content in WC Powders

  • 摘要: 采用超细颗粒(0.35μm)钨粉与不同粒径(0.1,0.3,0.8,4.5μm)的碳黑粉,按W+C=WC的反应式配碳,在氢气保护下,于830~1300℃保温40min,研究碳黑粒径、碳化温度对WC粉的化合碳含量及物相组成的影响.XRD分析物相组成,用化学分析测定碳含量(质量分数)结果表明:当使用0.1μm的超细碳黑,温度大于930℃时,WC粉的含碳量可达理论含量.但是在此温度下,随着使用的碳黑粒径增大,WC粉中的化合碳含量急速下降,例如在950℃下,使用0.3μm的碳黑只能使WC粉化合碳达到5.2%,使用0.8 μm碳黑时,WC的化合碳为3.18%.

     

    Abstract: With the ultrafine W powder (0.35 μm) and carbon black powders of various shes(0.1, 0.3, 0.8, 4.5 μm), the influences of carbon black pride size and carburization temperatures(830-1300℃ for 40 min) on the compounded carbon content and phase compositions in WC powders were investigated at the atmosphere of H2. The adding amount of carbon was determined under the reaction equation of W+C=WC. The phase compositions of the reacted products were analyzed by XRD. The experimental results demonstrated that when ultrafine carbon of 0. 1 μm was used, the compounded carbon content in the WC powders was up to 5.8%(mass fraction), corresponding to 95% of the theoretical content, at very low temperature of 850℃; when the temperature was higher than 930℃, the carbon content of WC powders approached the theoretical one. It is concluded that carburization can be completed at very low temperature when the ultrafine carbon black powders are used, in which the ultrafine W particles are carbonized before the they begin to grow and form W aggregation.

     

/

返回文章
返回