陈明, 童朝南. 基于LMI的鲁棒H容错动态输出反馈控制设计[J]. 工程科学学报, 2009, 31(5): 648-654. DOI: 10.13374/j.issn1001-053x.2009.05.022
引用本文: 陈明, 童朝南. 基于LMI的鲁棒H容错动态输出反馈控制设计[J]. 工程科学学报, 2009, 31(5): 648-654. DOI: 10.13374/j.issn1001-053x.2009.05.022
CHEN Ming, TONG Chao-nan. Design of robust H fault-tolerant output feedback control based on LMI[J]. Chinese Journal of Engineering, 2009, 31(5): 648-654. DOI: 10.13374/j.issn1001-053x.2009.05.022
Citation: CHEN Ming, TONG Chao-nan. Design of robust H fault-tolerant output feedback control based on LMI[J]. Chinese Journal of Engineering, 2009, 31(5): 648-654. DOI: 10.13374/j.issn1001-053x.2009.05.022

基于LMI的鲁棒H容错动态输出反馈控制设计

Design of robust H fault-tolerant output feedback control based on LMI

  • 摘要: 针对线性不确定系统,研究了其执行器失效情况下鲁棒容错H动态输出反馈控制设计问题.基于连续型执行器故障模型,利用线性矩阵不等式(LMI)方法提出了线性不确定系统动态输出反馈H容错控制器存在的充分条件,给出了动态输出反馈H控制器的设计方法.所获得的控制器不仅能使故障系统鲁棒稳定,并且能达到给定的H性能指标.仿真实例证明了所提出设计方法的有效性.

     

    Abstract: For linear uncertain systems with actuator faults, the problem of robust fault-tolerant H dynamic output feedback control was studied. Based on an actuator failure model with continuous gain, the sufficient condition for dynamic output feedback H robust fault-tolerant controllers was proposed by using a linear matrix inequality (LMI) approach, and the corresponding design method of a dynamic output feedback H controller was given. The proposed controller not only enables the system to keep robust stabilization but also achieves the given H performance. A simulation experiment shows that the proposed method is effective.

     

/

返回文章
返回