李文博, 包燕平, 王敏, 林路. 不同脱砷剂钢液脱砷研究[J]. 工程科学学报, 2015, 37(10): 1305-1312. DOI: 10.13374/j.issn2095-9389.2015.10.008
引用本文: 李文博, 包燕平, 王敏, 林路. 不同脱砷剂钢液脱砷研究[J]. 工程科学学报, 2015, 37(10): 1305-1312. DOI: 10.13374/j.issn2095-9389.2015.10.008
LI Wen-bo, BAO Yan-ping, WANG Min, LIN Lu. Dearsenization study of molten steel with different dearsenization agents[J]. Chinese Journal of Engineering, 2015, 37(10): 1305-1312. DOI: 10.13374/j.issn2095-9389.2015.10.008
Citation: LI Wen-bo, BAO Yan-ping, WANG Min, LIN Lu. Dearsenization study of molten steel with different dearsenization agents[J]. Chinese Journal of Engineering, 2015, 37(10): 1305-1312. DOI: 10.13374/j.issn2095-9389.2015.10.008

不同脱砷剂钢液脱砷研究

Dearsenization study of molten steel with different dearsenization agents

  • 摘要: 为了充分利用我国含砷铁矿资源,采用CaO+CaF2、CaC2+CaF和Si-Ca-Ba合金+CaF2对钢液进行脱砷研究,获得较高的脱砷率,其中Si-Ca-Ba合金+CaF2脱砷效果最明显,其脱砷率最高可达67.7%.在相同实验操作条件下,通过实验室研究,分析比较了温度、传质系数和S含量对不同脱砷剂脱砷效果的影响.

     

    Abstract: To make full use of symplesite resources in China,CaO + CaF2,CaC2+ CaF2 and Si-Ca-Ba alloy + CaF2 were used as an agent in molten steel dearsenization experiment. The Si-Ca-Ba alloy + CaF2 agent shows the most obvious dearsenization effect.Their dearsenization rate is as high as 67.7%. Under the same operation conditions,the effects of temperature,mass transfer coefficient and S content on the dearsenization of the three dearsenization agents were analyzed and compared by laboratory research.

     

/

返回文章
返回